Table of Contents
Advertisement
Reinstalling at a new location
1.
2.
Preparing Vivid S5/Vivid S6 for scanning
1.
2.
3.
4.
5.
6.
7.
Note: Ensure that the probe cables do not protrude from the
unit or interfere with the wheels, or foot area. The Hanging
cords may cause damage to system if lodged or hooked onto
nearby items. By ensuring cords are secure and out of lower
portion of the system, this may provide a more secure
atmosphere and avoid unnecessary damage.
Avoiding possible hazards
•
•
•
Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
When the unit is in place at a new location, lock the wheel
brakes (see "Moving and transporting the unit" on page 64).
Follow the installation procedure described on "Connecting
the unit" on page 54.
Lock front Wheel brakes
Un-Wrap the AC power cord and plug into power source.
Lift the LCD screen to the fully open position while pulling
out the lock. Secure the Monitor at full upright position.
Turn the system on.
Connect external cables if needed (LAN, USB, etc.).
Probe being used to scan should be ready, with cables
clear of foot area and wheels by wrapping un-used portion
of the cord on respective hooks provided.
Adjust keyboard's height and swivel (see page 93).
Avoid dragging cables on the floor. In cases where the
wheel rolls over cable or person pushing the system steps
on cables, it may generate severe force to break the cable
or the connector.
Avoid hanging cables beyond sides of the system. When
system is moved, these cables may be caught in
door-knobs or other medical equipment and apply severe
forces that may break probe cables or connectors.
Check that the Gel bottle is not interfering with the folding
screen. The gel bottle needs to be placed with dispenser tip
down into gel holder or moved sideways in order not to
push on the LCD frame (see Figure 2-9).
Getting started
67
Advertisement
Table of Contents
