Towing Or Winching; Parking Brake Release; After Use Each Day; Hour Meter - Snorkel SL30SL Operator's Manual

T W
OWING OR INCHING
Perform the following only when the machine will not operate under its own power and it is necessary to
move the machine or when winching onto a transport vehicle (see "Transporting the Work Platform" on
page 13).
C A U T I O N
DO NOT tow or winch the machine faster than 0,3 m/s (1 ft./s). Faster speeds will damage drive
components and void the warranty.
BRAKE RELEASE PUMP
Perform the following only when the machine will not operate under it's own power and it is necessary to
move the machine or when towing the machine up a grade or onto a trailer to transport.
1. Open the needle valve by turning the screw anti clockwise, this allows the wheels to freewheel.
2. Pump the Brake Release Pump until the Parking Brake is released.
3. The machine will now roll when pushed or pulled.
4. Be sure to close the needle valve and screw in the PC3 Valve with an allen key after undoing the locknut.
This will release the brake pressure.Once the brakes have been re-applied, return PC3 Valve to its
original configuration by fully unscrewing. Finally tighten the locknut.
Hand Pump
W A R N I N G
Never tow faster than 0,3 m/sec. (1 ft./sec.).
Never operate the work platform with the parking brakes released. Serious injury or damage could
result.

AFTER USE EACH DAY

1. Ensure that the platform is fully lowered.
2. Park the machine on a firm level surface, preferably under cover, secure against vandals, children and
unauthorized operation.
3. Turn the Chassis Key Switch to OFF and remove the key to prevent unauthorized operation.
4. Turn batteries off with master switch..

HOUR METER

To access the hour meter function perform the following steps.
1. Climb into the basket (with the machine powered up)
2. Push the platform emergency stop button.
3. Hold down the following buttons, Horn & Lift.
4. While holding the buttons twist the emergency stop button to return power to the machine.
5. "hr" will now be displayed on the readout, Pressing the right turn button will scroll through the
accumulated hours two digits at a time. For example, if pressing the right turn button once displays "20",
pressing it a 2nd time displays "58", and pressing it a 3rd time displays "hr", the elapsed time of operation
is 2058 hours.
Page 12
Needle Valve

Towing or Winching

Hand Pump
Operation Manual