Snorkel SL30SL Operator's Manual page 5

All personnel shall carefully read, understand and follow all safety rules and operating instructions before
operating or performing maintenance on any Snorkel aerial work platform.
Electrocution Hazard
THIS MACHINE IS NOT
INSULATED!
USE OF THE AERIAL WORK PLATFORM: This aerial work platform is intended to lift persons and his tools as well as the material used for the job.
It is designed for repair and assembly jobs and assignments at overhead workplaces (ceilings, cranes, roof structures, buildings etc.). All other uses
of the aerial work platform are prohibited!
THIS AERIAL WORK PLATFORM IS NOT INSULATED! For this reason it is imperative to keep a safe distance from live parts of electrical
equipment!. DO NOT get closer than the minimum distance recommended by the "National Regulations".
Exceeding the specified permissible maximum load is prohibited! See "Special Limitations" for details.
The use and operation of the aerial work platform as a lifting tool or a crane (lifting of loads from below upwards or from up high on down) is
prohibited!
NEVER exceed the manual force allowed for this machine. See "Special Limitations" for details.
DISTRIBUTE all platform loads evenly on the platform.
NEVER operate the machine without first surveying the work area for surface hazards such as holes, drop-offs, bumps, curbs, or debris; and
avoiding them.
OPERATE machine only on surfaces capable of supporting wheel loads.
NEVER operate the machine when wind speeds exceed this machine's wind rating. See "Beaufort Scale" for details.
NEVER attach notice boards ect. to the platform, as this will increase the wind loading effect.
IN CASE OF EMERGENCY push EMERGENCY STOP switch to deactivate all powered functions.
IF ALARM SOUNDS while platform is elevated, STOP, carefully lower platform. Move machine to a firm, level surface.
Climbing up the railing of the platform, standing on or stepping from the platform onto buildings, steel or prefab concrete structures, etc., is
prohibited!
Dismantling the swing gate or other railing components is prohibited! Always make certain that the swing gate is closed and securely locked!
It is prohibited to keep the swing gate in an open position (held open with tie-straps) when the platform is raised!
To extend the height or the range by placing of ladders, scaffolds or similar devices on the platform is prohibited!
NEVER perform service on machine while platform is elevated without blocking elevating assembly.
INSPECT the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, loose wire connections, and damaged cables or
hoses before using.
VERIFY that all labels are in place and legible before using.
NEVER use a machine that is damaged, not functioning properly, VERIFY that all labels are in place and legible before using.
To bypass any safety equipment is prohibited and presents a danger for the persons on the aerial work platform and in its working range.
NEVER charge batteries near sparks or open flame. Charging batteries emit explosive hydrogen gas.
Modifications to the aerial work platform are prohibited or permissible only at the approval of the manufacturer.
AFTER USE, secure the work platform from unauthorized use by turning both keyswitches off and removing key.
The driving of MEWP's on public highways is subject to Regulations made under the Road Traffic Acts.
ENVIRONMENTAL TEMPERATURE LIMITATION, The machine is primarily for use in normal ambient temperatures and conditions
.
ranging between 50c to -20c
OPERATION MANUAL
WARNING
Safety Rules
Tip Over Hazard
NEVER elevate the platform or drive
the machine while elevated unless the
machine is on a firm, level surface.
Collision Hazard
NEVER position the platform
without first checking for overhead
obstructions or other hazards.
Fall Hazard
NEVER climb, stand, or sit on
platform guardrails or midrail.
Page 1