Maintenance; Blocking The Elevating Assembly - Snorkel SL30SL Operator's Manual

M
AINTENANCE
W A R N I N G
Never perform service while the platform is elevated without first blocking the elevating assembly.
DO NOT stand in the elevating assembly area while deploying or removing the JackStand.

BLOCKING THE ELEVATING ASSEMBLY

INSTALLATION
1. Park the work platform on firm, level ground
and leave the engine running.
2. Ensure the Chassis Emergency Stop Button is
twisted to the ON position.
3. Press and hold the Chassis LIFT and ENABLE
buttons to elevate the platform approximately
305 mm (12 inches).
4. Place a jackstand with a minimum rating of
2000 kg (4000 lbs.) between the lower mast
and chassis, just behind the front axle.
5. Press and hold the Chassis DESCEND and ENABLE buttons to lower the platform until jackstand is
secured tightly between lower mast and Chassis.
REMOVAL
1. Press and hold the Chassis LIFT and ENABLE buttons to elevate the platform until the jackstand can be
removed.
2. Remove jackstand.
3. Press and hold the Chassis DESCEND and ENABLE buttons to completely lower the platform.
Page 14
Lower Mast

Maintenance

Figure 6: JackStand
DO NOT lift
or support the
front of platform
Jackstand
Operation Manual