Table of Contents
Advertisement
2 PREPARATION FOR USE
2.1
General Information
Unpack the Analyzer and other accessories. Check the contents of the package
against the list specified in section 1.4.1. Connect your A334M to AC power
source by means of the AC Power Cord supplied with the equipment.
Warm-up the Analyzer for 20 minutes after turning the power on.
Assemble the test setup using cables, connectors and etc, which allow DUT
connection to the Analyzer.
Perform calibration of the Analyzer. Calibration procedure is described in
section 4.1.3.
2.2
Front Panel
The front view of A334M is represented in figure 2.1. The front panel is
equipped with the following parts:
2.2.1 Power Switch
Figure 2.1 A334M Front Panel
Switches the initial condition power supply of the
Analyzer on and off.
Advertisement
Table of Contents
