Table of Contents
Advertisement
Removing Fixed Glass Assembly- Exterior
• Remove vanity panel from appliance to expose glass
latches.
• Pull glass latch out to release. Grasp glass assembly on
sides and pull bottom toward you. Slide glass assembly
down and out from under glass retainer.
GLASS RETAINER
GLASS LATCHES
9.5 Glass Latch Locations - Exterior Side
GLASS LATCH
GLASS LATCH
9.6 Glass Assembly - Exterior Side
Replacing Fixed Glass Assembly - Exterior
• Slide top of glass assembly into position under glass
retainer. Position bottom of glass assembly and secure
glass latches.
• Replace vanity panel.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath
the firebox.
Outdoor Lifestyles by Hearth & Home Technologies • TWILIGHT-IFT Installation Manual • 2668-970 Rev. C • 3/21
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Lava Rock and Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Placing Lava Rock
Place lava rock on refractory support pan. Cover entire
support pan surface (see Figure 9.7).
Figure 9.7 Placement of Lava Rock
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports.
• When placing Glowing Embers
should be taken so that the ports are not covered. Place
the dime-size ember pieces just in front of the port trail,
but not on or in between the ports (see Figure 9.8). Fail-
ure to follow this procedure will likely cause lighting and
sooting problems.
Figure 9.8 Placement of Ember Materials
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
®
onto the burner care
33
Advertisement
Table of Contents
