Hearth & Home Outdoor Lifestyles TWILIGHT-IFT NG Installation Manual page 29

WARNING
Fire Risk.
Finish all edges and fronts to clearances
and specifications listed in manual.
• Black metal columns may be covered with
non-combustible material only.
• Do NOT overlap combustible materials onto appliance
front.
• Install combustible materials only up to specified
clearances on top, front and side edges.
• Seal joints between the finished wall and appliance top
and sides using only a 300 ºF minimum sealant.
NOTICE: If using an acid-based wash to clean finishing
material, cover the face of the fireplace with plastic sheet
to protect the paint. Remove plastic before operation of
fireplace.
Outdoor Lifestyles by Hearth & Home Technologies • TWILIGHT-IFT Installation Manual • 2668-970 Rev. C • 3/21
Finishing Material:
1 Inch Thick or Less - Overlap Fit Method
The TWI-MOD decorative barrier front can be installed
with finishing materials up to one inch thick.
DECORATIVE FRONT
Finishing materials 1 inch maximum thick.
Stop finishing material flush with opening.
Figure 8.10 Finishing Material 1 Inch Thick or Less
1 in. MAX.
FINISHING MATERIAL
(TOP EDGE)
NON-COMBUSTIBLE
FINISHING MATERIAL
29