Appliance Setup; Fixed Glass Assembly - Hearth & Home Outdoor Lifestyles TWILIGHT-IFT NG Installation Manual

9 9

Appliance Setup

A. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly- Interior
• Loosen and remove two wing nuts on top glass retainer
bracket. Remove glass retainer bracket. See Figure 9.1
• Lift glass assembly tabs up and out of the slots in the
bottom glass frame mounting brackets.
Replacing Fixed Glass Assembly - Interior
• Position glass assembly with the bottom tabs positioned
inside the slots of the bottom glass frame mounting
brackets. See Figures 9.2 and 9.4.
• Position top of glass assembly, position top glass retainer
bracket with the arrows pointing downward, and secure
with two wing nuts. See Figures 9.1 - 9.3.
GLASS RETAINER
ARROWS POINT
DOWNWARD
WING NUT LOCATIONS
9.1 Glass Assembly - Wing Nut Location
32
Outdoor Lifestyles by Hearth & Home Technologies • TWILIGHT-IFT Installation Manual • 2668-970 Rev C • 3/21
WING NUT
SLOTTED BOTTOM GLASS
FRAME MOUNTING
BRACKETS (2)
WING NUTS (2)
9.2 Glass Assembly - Removed
WING NUT ON THREADED STUD WING NUT ON THREADED STUD
9.3 Glass Retainer Bracket & Wing Nut Detail
BOTTOM GLASS FRAME BOTTOM GLASS FRAME
TABS SEATED IN SLOTTED TABS SEATED IN SLOTTED
GLASS FRAME MOUNTING GLASS FRAME MOUNTING
BRACKET BRACKET
9.4 Botton Glass Frame Detail
GLASS RETAINER BRACKET GLASS RETAINER BRACKET