Hearth & Home Outdoor Lifestyles TWILIGHT-IFT NG Installation Manual page 20

Component Tray
The electrical components are installed on the compo-
nent tray. If it becomes necessary to remove the compo-
nents, use the information in Figure 6.2 to remove them
and reinstall them correctly on the component tray.
The IFT-ECM is held in position by two placement tabs
(front and rear) and one plastic pin on the component
tray. To remove the IFT-ECM, bend the rear placement
tab back slightly and tip the IFT-ECM to disengage it from
the pin and the shorter placement tab. To reinstall the
IFT-ECM on the component tray, engage the front place-
ment tab first.
The IFT-ACM (if equipped) is attached to the IFT-ECM and
is held in position by the rear placement tab. To remove
the IFT-ACM, bend the rear placement tab back slightly
and disengage the IFT-ACM from the IFT-ECM.
IFT-ECM
IFT-ECM
BATTERY PACK
POWER SUPPLY
WIRE
RETAINERS (4)
WIRE HARNESS
Figure 6.2 Electrical Component Tray
20
Outdoor Lifestyles by Hearth & Home Technologies • TWILIGHT-IFT Installation Manual • 2668-970 Rev C • 3/21