Application - Schwank SPW2-JZ Series Installation & Owner's Manual

WARNING
understand this installation and
operation manual thoroughly prior to assembly, installation, operation or service
to this appliance.
This heater must be installed and serviced only by a trained gas service techni-
cian.
Do not store or use gasoline or other flammable vapours and liquids in the vicinity
of this or any other gas fired appliance.
Failure to comply could result in personal injury, death, fire and/or property dam-
age.
Do not store or use gasoline or other flammable vapours and liquids in the vicinity
of this or any other gas fired appliance.
This appliance may have sharp edges and corners. Wear protective clothing such
as gloves and protective eye wear when servicing this or any other appliance.
California Proposition 65:
WARNING: This product can expose you to chemicals including carbon monoxide, which
is known to the State of California to cause birth defects or other reproductive harm. For more
information, go to www.P65Warnings.ca.gov
CERTIFICATION: SERIES SPW2-JZ, STW2-JZ(S), IWP2, IW2(S)
These series tube heaters are certified to:
• ANSI Z83.20 / CSA 2.34 Standard for Gas-Fired Low Intensity Infrared Heaters
• ANSI Z83.26 / CSA 2.37 Standard for Gas-Fired Outdoor Infrared Patio Heaters

APPLICATION

This model is approved for indoor and outdoor installation. A gas-fired radiant tube heater may
be installed INDOORS for heating of commercial / industrial non-residential spaces, or OUT-
DOORS for commercial/residential patios.
It is beyond the scope of these instructions to consider all conditions that may be encountered.
Installation must conform with all local building codes or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA 54 in the U.S.A. or the Natural Gas and Propane
Installation Code, CSA B149.1 in Canada. The latest edition Electrical Code ANSI/NFPA N0 70
in the U.S.A. and PART 1 CSA C22.1 in Canada must also be observed.
Installation of a gas fired tube heater must conform to all heating installation procedures includ-
ing clearance to combustibles, connection to the gas and electrical supplies, and ventilation.
This heater is not for installation in a Class 1 or Class 2 explosive environment, nor a resi-
dence. If installation of this equipment is in question, consult with local authorities having juris-
diction (Fire Marshall, labor department, insurance underwriter, or others).
Revisions to codes and/or standards, may require revision to equipment and installation proce-
dures. In case of discrepancy, the latest codes, standards, and installation manual will take pri-
ority over prior releases.
SERIES SUMMARY
Series SPW2-JZ and IWP2 have a powder coated water resistant burner enclosure and
aluminized steel tube/reflector system. These models may be installed to heat commercial /
residential outdoor spaces and indoor non-residential wet environments.
SPW2, STW2(S) / IWP2, IW2(S) I&O Manual
IM170629
RL: 03C
RD: APR 2019
Improper installation, adjustment, alteration, service or mainte-
nance can cause property damage, injury or death. Read and
4
continued ...