Schwank SPW2-JZ Series Installation & Owner's Manual page 16

BURNER ON
LOWER SIDE
JS-0504-JZ REFLECTOR ANGLE ADAPTER -JZ SERIES
1. A reflector angle adapter can be
installed on either side or both
sides of an elbow, depending up-
on site requirements for angling
of reflectors
2. The angle adapter is installed on
the 'flat' side of the webbed hang-
er (concave side of hanger must
face inward towards the elbow)
3. Rotate the angle adapter around
the tube to the desired angle of
the reflector - established by the
tube/reflector system hangers lo-
cated before or after the elbow
4. Align one of the holes in the angle adapter with the hole at top center of the elbow/tube
hanger
5. Bolt the angle adapter to the elbow/tube hanger through the aligned holes
6. The angle adapter will remain in place by resting on the tube
7. Attach reflector to the angle adapter with sheet metal screws
SPW2, STW2(S) / IWP2, IW2(S) I&O Manual
IM170629
RL: 03C
RD: APR 2019
#11/A
Suspend with 3 chains in horizontal posi-
tion and continue installing the tubes and
reflectors to complete the system.
#11/B
When hanging a heater with a 180° el-
bow kit at 45° angle the vent run tubes
must be on top, with the burner on the
lower side.
7
16
5