Application - Schwank SPW-JZ Installation & Owner's Manual

WARNING
Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury or death. Read and understand this installation and
operation manual thoroughly prior to assembly, installation, operation or service
to this appliance.
This heater must be installed and serviced only by a trained gas service techni-
cian.
Do not store or use gasoline or other flammable vapours and liquids in the vicinity
of this or any other gas fired appliance.
Failure to comply could result in personal injury, death, fire and/or property dam-
age.
Do not store or use gasoline or other flammable vapours and liquids in the vicinity
of this or any other gas fired appliance.
This appliance may have sharp edges and corners. Wear protective clothing such
as gloves and protective eye wear when servicing this or any other appliance.

APPLICATION

This model is approved for indoor and outdoor installation. A gas-fired radiant tube heater may
be installed for heating of commercial / industrial non-residential spaces. It is beyond the scope
of these instructions to consider all conditions that may be encountered. Installation must con-
form with all local building codes or, in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54 in the U.S.A. or the Natural Gas and Propane Installation Code,
CSA B149.1 in Canada. The latest edition Electrical Code ANSI/NFPA N0 70 in the U.S.A. and
PART 1 CSA C22.1 in Canada must also be observed.
Installation of a gas fired tube heater must conform to all heating installation design procedures
including clearance to combustibles, connection to the gas and electrical supplies, and ventila-
tion.
This heater is not for installation in a Class 1 or Class 2 explosive environment, nor a resi-
dence. If installation of this equipment is in question, consult with local authorities having juris-
diction (Fire Marshall, labor department, insurance underwriter, or others).
Revisions to codes and/or standards, may require revision to equipment and installation proce-
dures. In case of discrepancy, the latest codes, standards, and installation manual will take pri-
ority over prior releases.
Models SPW-JZ and IWP have a powder coated water resistant burner enclosure and alu-
minized steel tube/reflector system. These models may be installed to heat commercial /
industrial non-residential outdoor spaces and wet indoor environments.
Models STW-JZ and IW have a stainless steel water resistant burner enclosure and alu-
minized steel tube/reflector system, and may be installed for heating of commercial / indus-
trial non-residential outdoor spaces and wet indoor environments.
Models STW-JZ2 and IW2 have a stainless steel water resistant burner enclosure and
stainless steel tube/reflector system for heating of harsh indoor/outdoor environments.
SPW-JZ, STW-JZ(2) / IWP, IW(2) I&O Manual
IM101229
RL: 13A
RD: MAY 2014
4