Makita PM7651H Technical Information page 31

6-12 Stop switch
6-12-1 Checking Stop switch
Check the continuity between the bullet terminals on the two lead wires extending from Control lever with 1R402-A.
If Stop switch functions properly, there will be no continuity with the switch ON and there will be continuity with the switch OFF.
6-13 Fuel tube section
6-13-1 Fuel tube routing
Fig. 6-13-1-1
[1] Assemble Fuel tube and Filter to Fuel tank.
Fuel tube 3-370
Note: The length of tube from
Fuel tube 3-370 (black)
Note: The length of tube from
Grommet is 210mm.
Breather
Grommet
Filter
Hose clamp
[3] As the routing to Carburetor, refer to Fig. 6-11-5-2 in page 29.
ON
OFF
Control lever
(transparent blue)
Grommet is 215mm.
Fuel tank cap
assembly
Caution
plate
Fuel tank
Fig. 6-12-1-1
1R402
[2] Before inserting Tube guard 20-160 to Carburetor, put
Tube guard on three tubes.
Black
31 / 41
Fig. 6-13-1-2
Tube guard 20-160
(black)
Note: Put Tube guard
on three tubes.
Black