Makita PM7651H Technical Information page 26

Fig. 6-10-2-4
[5] While turning Reel counterclockwise, mount it in Starter case
complete. Then hook the inner end of Spiral spring in the slit of
the shaft portion of Starter case complete.
Note: You don't need to use force to mount Reel in place.
Shaft portion of
Starter case complete
Fig. 6-10-2-6
[7] Hook Starter rope on the U-shaped notch of Reel. Then,
while pulling Starter rope, turn Reel counterclockwise.
Release Starter rope from the U-shaped notch and
Starter rope will be wound around Reel due to the
rotational force of Spiral spring. Repeat this operation
until the slack is completely removed from Starter rope.
Note: With Recoil removed from the machine, pull Starter
knob to the full, and check that Reel is turned one turn.
Starter case complete
Reel
Starter rope
Inner end of
Spiral spring
Slit
[8] After installing Recoil to the machine, turn over Starter
Starter knob
U-shaped notch
26 / 41
Fig. 6-10-2-5
[6] Set Collar and two Swing arms in place on Reel.
Be sure to insert each Swing arm through the
slot of Reel. Then fasten them to Reel with 5x12
Tapping screw.
Note: Reel is not properly set in place if the rotation
of Reel is slow after the screw is fastened. In
this case, repeat steps [5] and [6] until normal
rotation of Reel is obtained.
Swing arm
Collar
Reel
Fig. 6-10-2-7
knob as shown below, and check that it is returned in
place.
スタータノブ
Starter knob
Slot of Reel
Recoil