Makita PM7651H Technical Information page 17

Petrol mist blower

Hide thumbs Also See for PM7651H:

6-7

Blower section

6-7-1

Disassembling

[1] Remove two M6x20 Pan head screws, and remove Frame complete.

[2] Remove Lower frame holder and Compression spring 17 from Frame holder.

Frame complete

M6x20 Pan head

screw (2 pcs.)

[3] Remove two Tank holders from the threaded rods of Volute case 1 with a wrench.

[4] Pull out two Compression springs 20, then remove the other two Tank holders.

[5] Remove three 5x20 Tapping screws, and remove Fan guard.

[6] Remove nine 5x20 Tapping screws and two M5x65 Pan head screws, and remove Volute case 1 from Volute case 2.

Note: Be sure not to lose M5 Hex nut.

M5x65 Pan head screw (2

Note: The other M5 Hex

nut is in the back.

Fig. 6-7-1-1

Fig. 6-7-1-2

Fig. 6-7-1-3

pcs.)

Elbow

17 / 41

Lower frame

holder

Compression

spring 17

Threaded rod of Volute case 1

Compression

Tank holder

spring 20

Volute case 1

5x20 Tapping

screw (9 pcs.)

5x20 Tapping

screw (3 pcs.)

Fan guard

Frame holder