Makita PM7651H Technical Information page 14

6-5 Control cable
6-5-1 Disassembling
Fig. 6-5-1-1
[1] Cut and remove Wire band with cutting pliers.
Wire band
[2] Remove Control cable and ON/OFF switch cords from the hook of Volute case 2, then disconnect the bullet terminal of
ON/OFF switch cords. (Fig. 6-5-1-2)
[3] Remove Control cable and the high voltage cable of Ignition coil from the wire holder of Volute case 2. (Fig. 6-5-1-3)
[4] Pull Control cable out of the space between Volute case and Air cleaner cover complete. (Fig. 6-5-1-4)
[5] Remove Control cable from Carburetor. (Fig. 6-5-1-5)
Fig. 6-5-1-4
Air cleaner case complete
Volute case
Fig. 6-5-1-3
Control cable
High voltage
Wire holder
6-5-2 Assembling
Note: Be careful not to bend Control cable.
[1] Pass the inner cable of Control cable through Adjust screw and Adjust nut, then route it in the groove of Swivel and then hook
the cable end on Swivel. (Fig. 6-5-1-5)
[2] Put Control cable in the space between Volute case and Air cleaner cover complete. (Fig. 6-5-1-4)
[3] Fix Control cable and the high voltage cable of Ignition coil in the cable holder of Volute case 2.
Be sure to fix Control cable first, then the high voltage cable.
Make sure that Control cable is tight and vertically straight. (Fig. 6-5-1-3)
[4] Connect the bullet terminal of ON/OFF switch cords securely. (Fig. 6-5-1-2)
[5] Hold Cable tube to Elbow with a new Wire band that holds. (Fig. 6-5-1-1)
Control
cable
cable
Fig. 6-5-1-5
Fig. 6-5-1-2
14 / 41
Control Adjust screw
cable
Adjust nut
Inner cable
Swivel Carburetor
Cable end
Bullet terminal
ON/OFF switch cord
Control cable
of Switch complete
Hook