Makita PM7651H Technical Information page 23

6-9-5 Removing Ignition coil
Remove Wire (primary wire) from Ignition coil, then remove Ignition coil from the engine by loosening two M4x20 Socket
head bolts.
6-9-6 Mounting Ignition coil
[1] Insert 0.3mm leaf of Feeler gauge set (1R366) between Ignition coil and the magnet of Flywheel complete. Ignition coil
will be attracted to the magnet through the Feeler gauge. Then, without removing the Feeler gauge, fasten Ignition coil to
the engine with two M4x20 Socket head bolts.
[2] Remove the Feeler gauge. Then make sure that Flywheel complete does not touch Ignition coil by turning it by hand.
Flywheel
complete
Ignition coil
Fig. 6-9-5-1
M4x20 Socket
head bolt (2 pcs.)
Fig. 6-9-6-1
23 / 41
Ignition coil
Wire (primary
wire)
Air gap must be
0.3 mm.