Factory Settings - Yale real Living Assure Lock Installation And Programming Instructions

Resetting Lock to Factory Default
When resetting the lock, all user codes,
including the Master
programming features are reset to original
default settings (see below).
1. Remove the battery cover and batteries.
2. Remove the interior lock to access the reset
button hole. (See image at right.)
3. Re-insert 3 batteries and insert a small
screwdriver into the hole; holding the reset
button for 3 seconds.
4. While still holding the reset button, insert the
4th battery and hold the reset button for an
additional 3 seconds.
5. Release the reset button.
6. Re-install the interior lock onto the door.
Upon reset, Master
only option available and must be performed
prior to any other programming of the lock.
For best results, the lock should be installed on the
door when resetting the lock to factory default. If the
process was done and the lock was not installed on
the door, review the Re-Handing instructions listed in
Hardware Troubleshooting.
Please use this procedure only when the network
primary controller is missing or otherwise inoperable

Factory Settings

Settings
Master
Audio Mode
Automatic Re-lock
Inside Indicator Light
One Touch Locking
Privacy Button Setting
Lockout Mode
Wrong Code Entry Limit
Shutdown Time
*The Master PIN
programming of the lock.
PIN code*, are deleted. All
PIN Code creation is the
PIN Code
code must be registered prior to any other
P/N YRL EMICL PBINSTL FUL -
Interior Lock
(4" Shown)
Factory Setting
Registration required*
Disabled
Disabled
Disabled (Off)
Enabled
Disabled
Disabled
5 Times
60 Seconds
32
- - Rev B