Hardware Troubleshooting; Factory Settings - Yale nexTouch Installation And Programming Instructions

Hardware Troubleshooting

Cycle lock in both the locked and unlocked positions. If problems are found:
Door is binding.
Latchbolt will not deadlock.
a. Either strike is out of alignment or the gap between door and jamb is too great.
Realign strike or shim strike out towards flat area of latchbolt.
Latchbolt does not retract or extend properly.
Latchbolt tail and retractor are not properly positioned:
a. Remove lockset. Look through 2-1/8" hole and verify latchbolt tail is centered
between top and bottom of hole.
b. Remove latchbolt and insert lockset. Look through latchbolt hole and verify retractor
mouth is centered in hole. If not, adjust outside rose plate.
c. If necessary, rebore holes to line up retractor and tail.

Factory Settings

Settings
Master PIN Code
Automatic Relock
One Touch Locking
Privacy Setting
Volume Setting
Language
All Code Lockout Mode
Wrong Code Entry Limit
Shutdown Time
*The Master PIN code must be registered prior to any other
programming of the lock.
Factory Setting
Registration required*
5 Seconds
Enabled
Disabled
High
English
Disabled
5 Times
60 Seconds
23
P/N 80-9150-0080-010 (10-17)