Advertisement
Quick Links
Advertisement
Related Manuals for Yale Real Living Touchscreen Lever
Summary of Contents for Yale Real Living Touchscreen Lever
- Page 3 2) cet appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement du dispositif. INTRODUCTION The Yale Real Living™ Stand-alone Touchscreen Lever Lock combines a robust lockset with a con- temporary electronic aesthetic. Users benefit from an interactive touchscreen that makes day-to-day access effortless, as well as offering voice-guided programming for simple updates to user information in the event of staffing changes or security breaches.
-
Page 5: Install Lock
INSTALL LOCK Preparation Before installing the lock on the door: Make sure door has been prepped according to specifications in template NOTE: included with lock. A. Remove the latch (Fig. A) and strike from the packaging. Both latch face and strike have adhesive-backed covers to prevent marring and should be removed upon installation. - Page 7 3. From outside of door, position the exterior escutcheon by first routing the wire harness through 2-1/8" diameter hole and under the latch (Fig. 4 & 5), then inserting the through posts* and tailpiece/square drive tube into the latch (Fig. 5). Interior of Door Exterior of Door "Top"...
-
Page 15: Status Indicators
Status Indicators Low Battery Warning Lockout Mode Return to previous step Definitions All Code Lockout Mode This feature is enabled by the Master PIN code. When enabled, it restricts all user PIN code access (except the Master PIN code). When the unit is in Lockout Mode, the red locked padlock (see above) will appear on the screen when attempting to enter a PIN code. - Page 17 To reset the lock to factory default, see the following: Reset Lock to Factory Default Reset Button The following procedure returns the lock to its factory defaults by deleting all user codes (including the Master PIN code*) and returning all programming features to their original factory default settings (see table below).
- Page 19 Feature Programming Through Menu Mode Using Master PIN code* 1. Touch the screen with the back of your hand or fingers to activate 2. Enter the 4-8 digit Master PIN code* followed by the key. Lock Response: “Menu mode, enter number, press the key to continue.”...
-
Page 21: Programming Troubleshooting
Programming Troubleshooting Symptom Suggested Action Lock does not respond – door is open and The touchscreen will become active when pressed with the back of hand or fingers in at least 3 areas accessible. simultaneously. Use a larger area of the hand or fingers and verify contact with at least 3 areas. If touchscreen numbers are visible, check to see if they respond when pressed. -
Page 23: Pin Code Management Sample Sheet
PIN CODE MANAGEMENT SAMPLE SHEET PIN Code Management (With Network Module - Up to 250 Users) - Duplicate Sheet to record entries User Type User Name User # PIN Code User User Name User # PIN Code Master User ___ User ___ User ___ User ___...
Need help?
Do you have a question about the Real Living Touchscreen Lever and is the answer not in the manual?
Questions and answers
Trying to increase the Automatic Re-lock Time, how can I get into the menu for that? I do have the network module installed.