Page 1
Yale Real Living™ Push Button Deadbolt Installation and Programming Instructions #8-32 x 5/16" Machine screws #7 wood & #8-32 machine x 20mm Combination screws M6x47mm Long through bolt P/N AYRD-210-INST-FUL Rev D...
Page 2
Preparing Door P/N AYRD-210-INST-FUL Rev D...
Page 3
Installing Latch & Strike Plate 2-3/8" position defaut 2-3/4" position optional Pull Press Bolt must be in retracted (unlocked) position. Note horizontal orientation of mechanism. P/N AYRD-210-INST-FUL Rev D...
Page 4
Installing Keypad Escutcheon Inside of Door Outside of Door Bolt must be in retracted (unlocked) position. Note horizontal orientation of mechanism. P/N AYRD-210-INST-FUL Rev D...
Page 10
Installing Optional Radio Module Installing Batteries & Cover "Welcome to Yale Real Living." Tighten screw to replace cover. Congratulations, you've installed the Yale Real Living™ Push Button Deadbolt! Turn sheet over for Programming Instructions to customize your product. P/N AYRD-210-INST-FUL Rev D...
Programming Instructions Low Battery Warning- Flashes RED Lock-out Mode- Keypad Flashes Master PIN Code must be created before any further programming. Max User Codes = 250 with Network Module. Max User Codes = 25 without. P/N AYRD-210-INST-FUL Rev D...
Page 13
Creating User PIN Codes Master PIN code must be created first. *Max user codes = 250 with Network Module. Max user codes = 25 without. Enter Master PIN code Press Press Press Press Enter User number (1-25) or (1-250)* Press Press Enter 4-8 digit PIN code Press...
Unlocking Door with PIN Code Enter PIN Press "Unlock" Code Chart Duplicate if necessary PIN Code Management (With Network Module - Up to 250 Users) User Type User Name User # PIN Code Master User ___ User ___ User ___ User ___ User ___ User ___...
Resetting Lock to Factory Default When lock is reset to factory defaults all user codes (including the Master PIN code*) are deleted and all programming features are reset to original default settings (see below). 1. Remove the battery cover and batteries. 2.
Page 16
Definitions All Code Lockout Mode: This feature is enabled by the Master code. When enabled, it restricts all user (except Master) PIN code access. When attempting to enter a code while the unit is in Lockout, the keypad flashes 8 times and the lock beeps 3 times as well.
Feature Programming Through Menu Mode Using Master PIN code* key. 1. Enter the 4-8 digit Master PIN code followed by the 2. Enter digit corresponding to the function to be performed followed by the key. *The Master PIN code must be registered prior to any other programming of the lock.
Programming Troubleshooting Symptom Suggested Action • Press each keypad button for response when pressed. • Check batteries are installed and oriented correctly (polarity) Lock does not respond – in the battery case. door is open and • Check batteries are in good condition; replace batteries* accessible.
Hardware Troubleshooting Cycle lock in both the locked and unlocked positions. If problems are found: Bolt will not deadlock a. Check for sufficient clearance of the bolt within the strike-side jamb. Correct this by increasing the depth of the pocket for the bolt. b.