Install And Charge The Battery - VTech IS8151-1S User Manual

Install and charge the battery

Install the battery
Install the battery as shown below.
NOTES
• Use only supplied battery.
• Charge the battery provided with this product only in accordance
with the instructions and limitations specified in this manual.
• If the handset will not be used for a long time, disconnect and
remove the battery to prevent possible leakage.
Charge the battery
Place the handset in the telephone base or the charger to
charge.
12 hrs
Once you have installed the battery, the handset LCD display
indicates the battery status (see the following table).
NOTES
• For best performance, keep the handset in the telephone base or
charger when not in use.
• The battery is fully charged after 12 hours of continuous charging.
• If you place the handset in the telephone base or the charger
without plugging in the battery, the screen displays No battery.
Battery indicators
The screen is The battery has no
blank, or displays or very little charge.
Place in charger The handset cannot
and flashes. be used.
The screen displays The battery has
enough charge to
Low battery and
be used for a short
flashes.
time.
The screen displays The battery is
HANDSET X.
charged.
When the battery is fully charged, you can expect the
following performance:
Operation
While in use (talking*)
While not in use (standby**)
* Operating times vary depending on your actual use and the age of
the battery.
** Handset is not charging nor in use.
6
Battery status Action
Charge without
interruption (at least 30
minutes).
Charge without
interruption (about 30
minutes).
To keep the battery
charged, place it in
the telephone base
or charger when not
in use.
Operating time
15 hours
10 days