Table of Contents
Advertisement
To configure the trunks you
must specify each telephone
number used on the circuit
connected to this port. If you
are using Channelized T1
you must also specify with
which channel of the T1
each telephone number is
associated. If you are using a
PRI line that has no trunk
groups and all channels are 2
way (inbound and outbound)
you can leave the Channel
field blank.
If your PRI line has trunk
groups OR has specific channels assigned for outbound calls OR is provisioned with
LESS than the 23 channel capability you can specify a range of channels that the
2101 must use for outbound calls for that phone number* (ie. 1-6 entered in the
Channel field next to a trunk number allows that phone number to make outbound
calls on channels 1-6 only). Studio facilities sharing the 2101 system simultaneously
should investigate trunk group options with their Telco provider to prevent
overwhelming the PRI line with a flood of calls during contesting and other high call
volume shows. Please refer to the 2101 PRI Ordering Form for more information on
Trunk Groups.
IMPORTANT!
Be sure to enter this information carefully. For a Channelized T1 line failure to
associate the correct channel with each phone number will cause the inability to
w
receive calls on that channel (far end party will hear ringing but the Series 2101 will
not recognize this incoming call). For a PRI line failure to enter the correct phone
numbers will prevent inbound calls from being properly routed to the Studio
Interfaces. (Far end party will hear a busy signal)
If you are using PRI, or a T1 protocol that uses Direct Inward Dialing/ANI (DID),
you should just enter each of your DID numbers associated with the digital telephone
circuit connected to that port. You must enter the same number of digits that will
be provided by the Telco on incoming calls. If your DID numbers are in a
consecutive range you can specify a range of numbers in the Phone Number field
separated by a hyphen.* If your PRI has been provisioned with trunk groups you
may need to also specify the channels used.
TELOS 2101 USER'S MANUAL
PART III
SERIES 2101 HUB
SECTION 4 – THE 2101 HUB WEB CONFIGURATION PAGES
III-33
Advertisement
Table of Contents
