Configuring Your Telco Trunks - Telos 2101 Series User Manual

1. Click on Create other. The following window will then be displayed.
2. Enter a name for your
protocol.
3. Select a Variant Type from
the drop down list
4. Select a Switch Type from
the drop down list
5. Click the Submit button and
your other protocol will be
created.
If you need help, please contact Telco to determine the switch model and
protocol variant used to provide your ISDN PRI service. Telos Systems
Customer Support may be able can advise you on the proper choices.

4.4.2 Configuring your Telco Trunks

To allow your system to work properly you must configure its Telco trunks. In the
case of PRI circuits, this can be used to reserve channels for outbound calls in case
the system is flooded with inbound traffic. In the case of channelized T1 this process
identifies the one-to-one relationship between telephone numbers and channels on the
T1.
HOT TIP!
Failure to configure trunks will prevent the system from recognizing incoming calls.
h
The trunks are configured by clicking on the Config trunk button for the desired port
from the NetAccess Configuration window (see picture in section 4.4.1 above). The
following Trunk Configuration screen will then be displayed:
III-32
TELOS 2101 USER'S MANUAL
PART III
THE SERIES 2101 HUB
SECTION 4 – THE 2101 HUB WEB CONFIGURATION PAGES