T-Link Interface Connector (Rev A T-Link Card)
The T-Link Interface (Rev A) is a standard modular RJ-45 style jack with the pin-out
shown above. Pin 1 is at the bottom. Since the Rev A version jack is identical on the
Hub and the Studio Interface, a special "crossover" cable is required (see Appendix 3).
IMPORTANT!
As with any piece of modern electronic gear, it is advisable that precautions be
taken to prevent damage caused by power surges. Special "T1" interface surge
w
protectors can be used to offer some degree of protection at the T- Link interface
jack. If the T- Link connection will run between two buildings this protection is
required. It is the user's responsibility to ensure that adequate protection is
provided.
T-Link interface cable (for use with Rev B T-Link card
Note: Pin 1 is to the left when viewed as above (with pins facing you and at the top).
III-16
TELOS 2101 USER'S MANUAL
PIN
FUNCTION
1
R1 (Input- from Studio)
2
T1 (Input- from Studio)
3
Not Connected
4
R (Output- to Studio)
5
T (Output- to Studio)
6
Not Connected
7
Not Connected
8
Not Connected
T-Link Interface cable.
PART III
THE SERIES 2101 HUB
SECTION 3 – INSTALLING THE SERIES 2101 HUB