Table of Contents
Advertisement
You will be running a connection from each System 2101 Studio Interface back to
one of the T-Link ports on the 2101 Hub. The T-Link jacks on the Hub are all
interchangeable – you may connect a given studio interface to any T-Link jack on the
Hub. You should use unshielded twisted pair cable rated Category 3 (Cat. 3) or
higher. We suggest you use Category 5 (Cat. 5) cable.
IMPORTANT!
Your T- Link connection(s) are in the Hub's Interface slots one through eight
counting from the left side of the unit as viewed from the rear. The RJ- 45 style
w
connectors closer to the right side (slots 10 & 11) are for the Telco Trunks, while the
jack furthest to the right (slot 12) is the Ethernet 100 Base- T jack.
T-Link interface connector (Rev B T-Link card)
The T-Link interface connector (Rev B) is a standard modular RJ-45 style jack with the
TELOS 2101 USER'S MANUAL
PIN
FUNCTION
1
R1 (Output- to Studio)
2
T1 (Output- to Studio)
3
Not Connected
4
R (Input- from Studio)
5
T (Input- from Studio)
6
Not Connected
7
Not Connected
8
Not Connected
pin-out shown above. Pin 1 is at the bottom.
PART III
SERIES 2101 HUB
SECTION 3 – INSTALLING THE SERIES 2101 HUB
III-15
Advertisement
Table of Contents
