Table of Contents
Advertisement
READ THE FOLLOWING BEFORE
CONNECTING POWER:
The AC receptacle connects mains power to the unit
with a standard IEC (International Electrotechnical
Committee) power cord. The power supply can
handle 120 volts AC or 240 volts AC. To change the
line voltage, you must open loosen the two knurled
screws and open the small door over the AC Mains
connector to access the power supplies inside. Then
remove each power supply by pulling on its handle
and set the voltage select switch appropriately. The
correct voltage setting must be selected on both power
supplies. Do not connect power until both power
supplies have been set to the local line voltage.
Please consult the markings on the switch and Power
Supply ratings plate for additional information.
WARNING!
The power supply can handle 120 volts AC or 240 volts AC depending on the
position of the voltage select switch located on each of the two redundant power
supplies.
e
In order to prevent damage to the power supply, or a potential safety hazard,
please sure to consult the markings on the switch and Power Supply ratings plate
for additional information.
IMPORTANT!
As with any piece of modern electronic gear, it is advisable that precautions be
taken to prevent damage caused by power surges. Standard line surge protectors
w
can be used to offer some degree of protection. It is the user's responsibility to
ensure protection adequate for their conditions is provided.
WARNING!
This equipment is designed to be operated from a power source anotherh
anotheres a third "grounding" connection in addition to the power leads.
e
Do not defeat this safety feature. In addition to creating a potentially hazardous
situation, defeating this safety ground will prevent the internal line noise filter
from functioning.
TELOS 2101 USER'S MANUAL
PART III
SERIES 2101 HUB
SECTION 3 – INSTALLING THE SERIES 2101 HUB
III-19
Advertisement
Table of Contents
