Table of Contents
Advertisement
FrmRESRV – For use by Telos only
FrmSF-SLC96 – For special applications only
Line Code. Set to match your digital telephone circuit. Options for this
parameter are:
CodB8ZS – B8ZS Line Coding: This is the usual option for PRI or T1
in the USA & Canada.
CodB7ZS – For special applications only
CodAMI – AMI Line Coding
Line Length. This represents the number of feet of cable between the
CSU and the 2101 Hub. Select the value closest to the amount of cable
(in feet) used.
E1 Interface Card Hardware Settings (EUROPE AND MOST COUNTRIES OUTSIDE
THE USA & CANADA)
For the PRI/E1 Interfaces (Telos Part #'s 2091-00015 and 2091-00016) you will
have the following options:
Framing Mode. Set to match your digital telephone circuit. The most
common choice is FrmCRC4. Options for this parameter are:
FrmCRC4 – CRC-4 Multiframe with Si= FEBE (Far End Block
Error).
FrmBASIC – Basic framing with no CRC4, Si=1. For special
applications only
FrmFEBE_CAS – CRC-4 with FEBE with TS16 Channel Associated
Signaling. For special applications only
FrmBASIC-CAS – Basic framing with TS16 Channel Associated
Signalling. For special applications only
FrmDISABLED – Framing on Timeslot 0 disabled. For special
applications only
FrmTS014-FEBE – TS014, Si=FEBE.=0 when not in frame
alignment. For special applications only
Line Code. Set to match your digital telephone circuit. Options for this
parameter are:
CodHDB3 – High Density Bipolar 3. This is the usual option for E1
based PRI as used in Europe.
CodTRANSPARENT – AMI: For special applications
SECTION 4 – THE 2101 HUB WEB CONFIGURATION PAGES
TELOS 2101 USER'S MANUAL
PART III
SERIES 2101 HUB
III-29
Advertisement
Table of Contents
