Table of Contents
Advertisement
IMPORTANT!
To apply the IP changes (IP address, Hub name, Subnet Mask, Gateway), the 2101
Hub must be 'hardware' rebooted. To do so, press the Reset button on the Hub front
panel.
w
If the 2101 Hub Is 'hardware' rebooted, all phone calls and the communication
with the Web Configuration Utility will get lost. Reconnect and log in again once
the reboot is complete.
A complete list of all System Options follows:
Advertise Port
The first field is the Advertise Port that the system will use. The default is port 8100.
This should not be changed. In the event that it is changed, you must be certain that
no other device on your network is using this port.
Host ID
The Host ID needs to be a "2101 System" wide unique number. It is recommended
that each 2101 hub in you system have a unique Host ID of less than 256. Most users
can leave the default. The only exception is when a two 2101 Hubs share the same
LAN, as when creating a dual redundant hub system. See Section 5 for more on this.
If your Series 2101 System includes two 2101 Hubs, then you will need to change
this number on one of them.
Law Mode
This field two different choices: MU-LAW and A-LAW. This is the voice coding
mode used and varies by country. MU-LAW is the U.S. standard (Default) and A-
LAW is the European standard. See Part IV section 3.3.2 for a chart of different
countries and the correct setting for each.
Time Out for Dial Out
This represents the amount of time in seconds before the system times out between
each dialed digit. The default is five seconds. For example, after dialing the first digit
of the number you are calling, you will have five seconds to dial the next digit before
the system times out.
Time Out on Seized
This field represents the amount of time in seconds it takes the system to Time Out if
a number is not dialed after picking up (seizing) a line. The default is ten seconds.
Generate Local Busy
When checked, this causes the 2101 to generate a busy tone to the local user in case
an outgoing call is rejected. By disabling it, the caller will only hear silence.
III-26
TELOS 2101 USER'S MANUAL
PART III
THE SERIES 2101 HUB
SECTION 4 – THE 2101 HUB WEB CONFIGURATION PAGES
Advertisement
Table of Contents
