See (see
on page 9).
5. If required, connect:
▪
The 5V/2A USB port
▪
The ETHERNET port
▪
The RS-232 port
6. Connect the power cord to the power connector
shown in
Figure
We recommend that you use only the power cord that is supplied with this machine.
Connecting Output to a Balanced/Unbalanced Stereo
Audio Acceptor
The following are the pinouts for connecting the output to a balanced or unbalanced stereo
audio acceptor:
Figure 4: Connecting to a Balanced Stereo Audio
Acceptor
Connecting to VS-88H2A via RS-232
You can connect to
VS-88H2A
features an RS-232 3-pin terminal block connector allowing the RS-232 to control
VS-88H2A.
Connect the RS-232 terminal block on the rear panel of
follows:
From the RS-232 9-pin D-sub serial port connect:
•
Pin 2 to the TX pin on the
block
•
Pin 3 to the RX pin on the
block
•
Pin 5 to the G pin on the
VS-88H2A – Connecting VS-88H2A
Connecting Output to a Balanced/Unbalanced Stereo Audio Acceptor
18
to the USB port of another device to charge it.
to a control device.
20
22
to a control device (not shown in
3).
VS-88H2A
via an RS-232 connection
VS-88H2A
RS-232 terminal
VS-88H2A
RS-232 terminal
VS-88H2A
RS-232 terminal block
Figure
and to the mains electricity (not
23
Figure 5: Connecting to an Unbalanced Stereo Audio
Acceptor
using, for example, a PC.
22
VS-88H2A
RS-232 Device
Kramer Electronics Ltd.
3).
to a PC/controller, as
VS-88H2A
9