Removal And Replacement Procedures For Customer Self-Repair Parts; Component Replacement Procedures; Preparation For Disassembly; Solid-State Drive - HP Victus 16z-e000 Maintenance And Service Manual

5 Removal and replacement procedures for
Customer Self-Repair parts
This chapter provides removal and replacement procedures for Customer Self-Repair parts.
NOTE: The Customer Self-Repair program is not available in all locations. Installing a part that is not
supported by the Customer Self-Repair program can void your warranty. Check your warranty to determine
whether Customer Self-Repair is supported in your location.

Component replacement procedures

To remove and replace computer components, use these procedures.
NOTE: Details about your computer, including model, serial number, product key, and length of warranty,
are on the service tag at the bottom of your computer.
NOTE: HP continually improves and changes product parts. For complete and current information about
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.

Preparation for disassembly

To remove and replace computer components, use these procedures.
See Removal and replacement procedures preliminary requirements on page 25
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.

Solid-state drive

To remove the solid-state drive, use this procedure and illustration.
Table 5-1 Solid-state drive descriptions and part numbers
Description
1 TB, PCIe
512 GB, PCIe
256 GB, PCIe
Before removing the solid-state drive, follow these steps:
for initial safety procedures.
Spare part number
L85348-001
L85360-001
L85350-001
33