Table of Contents
Advertisement
5
Removal and replacement procedures for
Customer Self-Repair parts
This chapter provides removal and replacement procedures for Customer Self-Repair parts.
NOTE:
The Customer Self-Repair program is not available in all locations. Installing a part not supported by
the Customer Self-Repair program may void your warranty. Check your warranty to determine if Customer
Self-Repair is supported in your location.
Component replacement procedures
NOTE:
Details about your computer, including model, serial number, product key, and length of warranty,
are on the service tag at the bottom of your computer. See
NOTE:
HP continually improves and changes product parts. For complete and current information on
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.
There are as many as 12 screws that must be removed, replaced, and/or loosened when servicing Customer
Self-Repair parts. Make special note of each screw size and location during removal and replacement.
Preparation for disassembly
See
Removal and replacement procedures preliminary requirements on page 27
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
Bottom cover
Table 5-1
Bottom cover description and part number
Description
Bottom cover
Before removing the bottom cover, follow these steps:
▲
Prepare the computer for disassembly
Remove the bottom cover:
1.
Turn the computer upside down on a flat surface.
32
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Labels on page 18
(Preparation for disassembly on page
for details.
for initial safety procedures.
Spare part number
L62728-001
32).
Advertisement
Table of Contents
Troubleshooting
