Memory Modules; Prepare The Computer For Disassembly (See Preparation For Disassembly - HP Victus 16z-e000 Maintenance And Service Manual

3. When installing a solid-state drive, be sure to install a thermal pad onto the bracket as shown in the
following illustration.
To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.

Memory modules

To remove the memory modules, use this procedure and illustration.
Table 5-2 Memory module descriptions and part numbers
Description
Memory module, 16 GB (DDR4-3200)
Memory module, 8 GB (DDR4-3200)
Memory module, 4 GB (DDR4-3200)
Before removing the memory, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
If you are replacing a memory module, remove the existing memory module:
Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then
▲
remove the module (2). Use the same procedure to remove all memory modules.
IMPORTANT:
Do not touch the components on the memory module.
Bottom cover on page
To prevent damage to the memory module, hold the memory module by the edges only.
Preparation for disassembly on page
37).
Battery on page
Component replacement procedures
Spare part number
L67710-001
L46598-001
L83673-001
33).
38).
35