Rear Vent; Remove The Heat Sink (See Heat Sink; Remove The Fan (See Fans; Solid-State Drive - HP Victus 16z-e000 Maintenance And Service Manual

Table 6-12 Rear fin description and part number
Description
Rear fin
Before removing the rear fin, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the right solid-state drive (near the WLAN module) (see
5. Remove the heat sink (see
6. Remove the fan (see
7. Remove the system board (see
Remove the rear fin:
1. Remove the three Phillips M2.0 × 2.0 screws that secure the fin to the computer (1).
2. Remove the fin from the computer (2).
Reverse this procedure to install the rear fin.

Rear vent

To remove the rear vent, use this procedure and illustration.
Table 6-13 Rear vent description and part number
Description
Rear vent
Before removing the rear vent, follow these steps:
52 Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 38).
Heat sink on page 41).
Fans on page 43).
System board on page
37).
Solid-state drive on page
47).
Spare part number
M54718-001
33).
33).
Spare part number
M54717-001