Rear Fin - HP Victus 16z-e000 Maintenance And Service Manual

2. Disconnect the touchpad cable from the ZIF connector on the touchpad (1).
3. Lift the shielding from the top of the touchpad (2).
4. Remove the three broad head Phillips M2.0 × 2.0 screws (3) from the touchpad.
5. Lift the top of the touchpad up (4), and then pull it away from the bottom of the computer to remove it
(5).
Reverse this procedure to install the touchpad.

Rear fin

To remove the rear fin, use this procedure and illustration.
Component replacement procedures 51