Description - Hilti TE 60 Original Operating Instructions

Obligation signs
Wear eye Wear a hard
protection hat
en
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Chisel position Volts
adjustment

2. Description

2.1 Use of the product as directed
The power tool is an electrically-powered combihammer with pneumatic hammering mechanism. The ATC
(Active Torque Control) feature incorporated in the TE 60‑ATC provides greater working comfort for the user
when drilling.
The tool is designed for drilling in concrete, masonry, metal and wood and can also be used for chiseling.
The power tool is equipped with electronic overload protection. If the power tool is overloaded for a continuous
period, motor speed will be reduced automatically and, if necessary, the motor may be stopped completely.
When the control switch is released and then pressed again, the motor immediately regains full power. When
restarting, care should thus be taken to ensure that the power tool is held securely with both hands.
Under certain conditions, the power tool is suitable for use for mixing (see "Tools, accessories" and
"Operation").
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction.
The power tool may be used only in a dry environment.
18
Alternating
current
Wear ear Wear
protection protective
gloves
Diameter
Location of identification data on the power tool
The type designation can be found on the type iden-
tification plate and the serial number on the side of
the motor housing. Make a note of this data in your
operating instructions and always refer to it when
making an enquiry to your Hilti representative or
service department.
Hammer Chiseling
drilling
Type:
Generation: 03
Serial no.:
Amps Watts
Hertz Rated speed Revolutions
under no load per minute
Double Equipped with Lock symbol
insulated theft
protection
system