Transferring And Comparing Settings; Transferring Io Device Terminal Setting Information Through The Usb Port On The Profinet Coupler Unit; Transferring Io Device Terminal Setting Infor- Mation Through The Usb Port On The Profinet Coupler Unit - Omron PROFINET NX-PNC202 User Manual

9 Setting Up the PROFINET Coupler Unit
9-3

Transferring and Comparing Settings

This section describes how to transfer and compare IO Device Terminal settings that you set on the
Support Software. The Sysmac Studio is used as an example.
For Support Software other than the Sysmac Studio, refer to the operation manual for the Support Soft-
ware that you are using.
9-3-1 Transferring IO Device Terminal Setting Information through the
USB Port on the PROFINET Coupler Unit
Always confirm safety at the destination before you transfer the Unit configuration
information, parameters, set values, or other data from the Sysmac Studio.
The devices or machines may operate unexpectedly, regardless of the operating
mode of the Controller.
You can connect the Sysmac Studio to the USB port on the PROFINET Coupler Unit to transfer the IO
Device Terminal settings information to the IO Device Terminal. With some Support Software, you can
connect through Ethernet any other method except for a USB port. Refer to the operation manual for
the Support Software for details.
Use the following procedure to transfer the settings.
1
Connect the Sysmac Studio to the peripheral USB port on the PROFINET Coupler Unit and
place it online.
2
Right-click the PROFINET Coupler Unit in the Edit IO Device Terminal Configuration Tab Page,
and select Coupler Connection (USB)  Transfer to Coupler.
The Transfer to Coupler Dialog Box is displayed.
3
Select the data to transfer.
• To transfer the configuration information, Unit operation settings, and Unit application data,
select Configuration Information + Unit Operation Settings + Unit Application Data.
• To transfer only the configuration information, select Configuration information only.
An execution confirmation dialog box is displayed.
9 - 16
WARNING
NX-series PROFINET Coupler Unit User's Manual (W623)