Wing Guide Chain - Progressive Turf Equipment TD 92 Operator's Manual And Parts List

WING GUIDING CHAIN:
In some conditions during the unfolding of the mower wings before
operating, the wing deck corner pin contacts the end of the supporting plate
and does not come to rest on the top of the plate. This is mainly caused by
either inadequate lubrication of the wing deck PTO shaft tubes or lowering
of decks while not stationary, on level ground.
The mowers make use of a guide chain connecting the wing deck and the
transport frame. This will ensure that the deck corner pin will not interfere
with the support plate and land on top of the plate.
ASSEMBLY INSTRUCTIONS
a) After the decks have been assembled to the frame, locate the guide chain on
the back corners of the wing decks closest to the transport tires.
b) Remove the bolt from the end of the chain.
c) Remove all twists from the chain. It must be straight or the total length of
chain will be too short.
d) With the bolt passing through the last link of the chain, and passing it over
the frame, mount it to the hole in the deck pin support plate on the inside of
the frame.
e) Tighten all bolts.
Transport Tire
Corner Pin
Wing Deck
Wing Deck Support
Once the decks and chains are on, raise the decks and fasten all 9 blades to the
bottom of the decks.
: (See photos below)
Guide Chain
18
Mower Frame