Cutting Height Adjustment - Progressive Turf Equipment TD 92 Operator's Manual And Parts List

CUTTING HEIGHT ADJUSTMENT

Mower cutting height adjustment is made by removing lynch pin from the
top of each castor stem (square or round) and corner support and moving
the spacers either above or below support tube as required for your selected
cutting height.
NOTE: Cutting height starts at 3/4", with no spacers under the bushing.
Increments are then 3/8" using 3/8" and 1" spacers.
Be sure all adjustments are set the same.
Spacers (3/8" & 1")
Bushing
:
23