Setting The Discharge Deflectors; Wing Frame Alignment - Progressive Turf Equipment Pro-Flex 120 Operators Manual And Parts Lists

6) On the pivoting wheel arm side
remove the two axle stop pins and the
center pivot bolt. Reposition the axle
to the proper hole for the desired
cutting height. Retighten the center
pivoting bolt properly.
7) Replace the two axle stop pins to the
same hole in the pattern as the axle
mounting bolts. This pin is used to
limit the travel of the mower deck
and prevent scalping. The pins are
not required for cutting heights of 2
3/4" and 3". Store pins in one of the
holes for the center pivoting bolt.

SETTING THE DISCHARGE DEFLECTORS

Each mower deck has its own discharge
deflector. This is a two position deflector that
can be adjusted by moving the spring clip on the
deflector. When set in the lower position it
deflects the cuttings downwards into the grass,
and when set in the upper position, the discharge
fans out more discharging the cuttings straight
out.
NOTE: In wet or heavy conditions, the deflector can be set in the upper most
position to help avoid clumping.

WING FRAME ALIGNMENT

When the wings are in the lowered position, the wing frame should be level with
the mower frame (this is pre-set at the factory). A stop bolt is located on the main
frame and can be adjusted so that the wing stops in a level position when lowered.
IMPORTANT! - Operating with the wings misaligned with the main frame
can cause excess stress on the wing drive belts, leading to accelerated wear.
23