Lubrication - Progressive Turf Equipment TD 92 Operator's Manual And Parts List


Check the properties of the grease you wish to use with your supplier prior to
use
.

LUBRICATION

A properly maintained lubrication schedule will provide a smooth running
machine for many years. All pivot locations have grease fittings. The
following information shows and describes where all lubrication points are
located.
.
DECKS

Spindles* (See Manual)

3 Pivots per Wing
Deck*

2 Pivots on Rear Deck*

Castor Wheel &
Swivels*
*As Required
CHECK FOR PROPER OIL LEVEL IN GEAR BOXES DAILY
GREASING SCHEDULE & LOCATION
BLADE SPINDLE GREASING
The top bearing on all spindle assemblies has a shield only. This allows
grease to exit and relieves any pressure build up inside spindle housing,
when greasing. Greasing of blade spindles should continue until grease can
be seen exiting between the top bearing and the bottom of hub on pulley.
Some working conditions will require this operation to take place every 4 to
5 running hours because of hot working areas. Cooler working areas will
only require greasing every 8 to 10 hours. A proper greasing schedule can
:
P.T.O. SHAFTS
 Main Input*(See
Below)
 Deck Drive, 4
Locations per Shaft*
 Pull Apart Sliding
Tubes once per week
and lubricate
*As Required
:
27
FRAME
 8 Pivot Locations*
 2 Wheels*
*As Required