Setting The Discharge Deflectors; Wing Frame Alignment - Progressive Turf Equipment Pro-Flex 120 Operators Manual & Parts Lists

5) Using a 9/16" wrench, loosen the lock bolt on each end of the
roller arm adjusting quadrant.
6) While supporting the roller arm using the integral handle, slide
the lock bolt on each quadrant so that it rests in the center
detent between the two adjustment positions.
7) Lift / lower the roller arm using the handle until the lock bolt
aligns with the adjustment slot in the quadrant that will yield the
desired cutting height (per the cutting height decal).
8) Tighten the lock bolt on each quadrant.
9) Repeat procedure for roller arm on opposite side of deck.

SETTING THE DISCHARGE DEFLECTORS

Each mower deck has its own discharge deflector. This is a two
position deflector that can be adjusted by moving the spring clip on
the deflector. When set in the lower position it deflects the cuttings
downwards into the grass, and when set in the upper position, the
discharge fans out more discharging the cuttings straight out.
NOTE: In wet or heavy conditions, the deflector can be set in the
upper most position to help avoid clumping.

WING FRAME ALIGNMENT

When the wings are in the lowered position, the wing frame should be
level with the mower frame (this is pre-set at the factory). A stop bolt
is located on the main frame and can be adjusted so that the wing
stops in a level position when lowered.
IMPORTANT! - Operating with the wings misaligned with the
main frame can cause excess stress on the wing drive belts,
leading to accelerated wear.
Pro-Flex 120 Series Operator's Manual
Lock Bolt Lock Bolt
Quadrant
Handle
27