Manual Accumulation - U-Line H-5819 Manual

CLEAR CHECK COUNT
1. Press the MODE key
the display.
MR
2. Press the HI key
on the display.
3. Enter 0 using the numeric keypad.
4. Press the ZERO key
5. Press the LO key MC
on the display.
6. Enter 0 using the numeric keypad.
7. Press the ZERO key
ACCUMULATION
Use this mode to measure the cumulative weight or
counting values of a sequence of items. The maximum
number of samples is 99 entries or the scale capacity.

MANUAL ACCUMULATION

1. Follow steps above to weigh or count items on the
platform.
2. Once the stable indicator is shown on the display,
press the M+ key
display and the total value will be displayed for two
seconds. Weighing or counting value will be stored
into memory. If a printer is connected, the data will
print. Once data is stored, the M+ indicator will be lit
up on the lower right-hand corner of the display.
AC 1
3. Remove items from the platform. Display will return to
zero or a negative value.
4. Add additional items to the platform.
5. Once the stable indicator is shown on the display,
press the M+ key
memory. Continue until all data is added.
6. If counting in accumulation mode:
• As the pieces are added, the total quantity will be
displayed.
• Press the U/N/G key
gross weight and total quantity.
PAGE 7 OF 33
OPERATION CONTINUED
C PCS
until is shown on
Mode
. Current high limit will be shown
HI
.
Zero
. Current low limit will be shown
LO
.
Zero
M AC 1
+ . will be shown on the
. New data will be added to
M
+
U/N/G
to display the unit weight,
RECALL DATA
1. Press the MODE key
the display.
ACCU
NOTE: If unit weight was preset or added to
memory, scale will automatically enter counting
mode when accumulation mode is selected.
MR
2. Press the MR key
value of items stored to memory. Number of
accumulated values and total weighed value will
be displayed for three seconds.
3. Press and hold the MR key
counted value of items stored to memory. Number of
accumulated values and total counted value will be
displayed for three seconds
CLEAR DATA
1. Press the MODE key
ACCU
2. To clear weighing and counting data stored to memory,
MC
press the MC key
AUTOMATIC ACCUMULATION
Use this mode to automatically add weighing and
counting values to the scale memory and to print values
if a printer is connected.
NOTE: Automatic accumulation must be
enabled. See Enable Automatic Accumulation
section on page 9.
When in the automatic accumulation mode, the auto
indicator will be shown in the upper righthand corner of
the display.
1. Place items to be weighed or counted on the platform.
2. Once the stable indicator is shown on the display,
the scale will make a beeping sound.
3. Remove items from the platform. Display will show
AC 1
followed by the weighing or counting value.
Weighing or counting value will be stored into
memory. Once data is stored, the M+ indicator will
be lit up on the lower right hand corner of the display.
AC 1
4. The scale will return to the weighing mode. Display
will return to zero or a negative value.
ACCU
until is shown on
Mode
to display the total weighed
HI
MR
to display the total
HI
ACCU
until shows on display.
Mode
CLEAR
. will show on display.
LO
0819 IH-5819