Table of Contents
Advertisement
REMOTE CONTROL
Specifications:
RF transceiver module, frequency 2.4 GHz - Powered
by two AAA 1.5 V batteries rated at least 1200 mAh.
ON/OFF button:
manual on/off button and for switching the remote
from energy saving mode to active heating
touch buttons:
+: increment button (increases the fireplace's power,
temperature or fan speed, etc., or scrolls through the
menu)
+: decrement button (decreases the fireplace's power,
temperature or fan speed, etc., or scrolls through the
menu)
M: menu key / relax mode key
OK: confirm key, switches to the next setting and
between automatic and manual modes
NOTES
•
The remote control does not store the programs,
which are stored on the logic board; there is thus
no need to reprogram it when it is shut off or
replaced by a new one.
•
The remote exchanges information with the logic
board (including room temperature sensing in
automatic mode) every 2" and when it is activated
by pressing the ON/OFF button.
•
In normal use, the remote's batteries should last a
year. This is an approximate value, since it depends
on both the type of batteries and the intensity of
use. Edilkamin and the reseller will not consider
claims for battery life under any circumstances. If
the battery charge is low, a warning displays at the
top left.
SENDING
SIGNAL
REMOTE
CONTROL
PRODUCT
BEEP.
IN ABSENCE OF ANY BEEP, THE
PRESSURE ON THE BUTTON WAS
TOO SHORT.
USER INSTRUCTIONS
FROM
THE
TO
THE
IS
CONFIRMED
BY
REMOTE CONTROL POWER SAVING
If the remote is not used for 20", the display turns off to
save power. The display turns black without text. This
condition refers solely to the remote itself, and not to
the fireplace.
To turn the display back on, press the ON/OFF button.
DO NOT PRESS THE ON/OFF BUTTON
REPEATEDLY; this turns the fireplace on
and off in manual mode
REMOTE CONTROL FIRST POWER ON
•
Open the back of the remote and insert the
two batteries in the indicated orientation.
•
hooked up electrically
•
THE AUDIBLE SIGNALS PRESS THE
ON / OFF BUTTON
Otherwise it will not work
If this is the first power on and the language has not
yet been set, the language selection page will display.
Select the language with the +/- keys and confirm
it with OK.You are now asked to confirm or set the
time and date.Set the values with the +/- keys and
confirm with OK. The day of the week is calculated
automatically using a perpetual calendar.
25
Hide quick links:
Advertisement
Table of Contents
