Explo X2 Wave Flamer Manual page 17

4.1.13 PUMP AND VENT PUMP
Allows you to pump the system and eject fluid without ignition. It is mainly used to vent the internal
system (Especially in combination with the solenoid valves and nozzle). Alternatively, can be used for
a test run of the Wave Flamer.
When using Pump and Ventpump the Wave Flamer will pump and vent multiple times.Afterwards,
the fluid can be ejected manually (automatic 45° leftward sloping of the head).
4.1.14 SOFTWARE VERSION
Shows the current software of the device. A regular checking and updating of the software is highly
recommended. You can find further informations for this at the end of this manual.
4.1.15 GROUP BOX
17
Shows the set Group box numbers. With the Mode/OK button you can switch to the next two Group
box number.
This option can only be used for manual ignition signals or for control with the PC-mode (ShowPlayer
software) via box- and channelnumber. Automated shows (AutoShow/ ShowCreator) and PC control
with an internal TimeCode do not allow for the usage of the Group box numbers set.