Keyline NINJA LASER Use And Maintenance Manual page 40

Warning:
Before carrying out any calibration activity out of the
ones described from paragraph 5.3.1 to para-
graph 5.3.5, please contact the technical service
centre, to avoid wrong manoeuvres.
5.3.1 Laser cutter Setup
How to proceed:
• From the CALIBRATIONS MENU, select:
• Change the position of the X-Y axes with the buttons:
• On the top left of the display it is possible to view the
height to be modified.
• Save your changes by pressing "1".
Note: If you leave the page without pressing the "1" key, all
changes shall be lost.
• To reset the changes and go back to the previous setting,
press "2".
12 Keyline S.p.A.
SETUP
5.3.2 Flat keys tracer Setup
How to proceed:
• From the CALIBRATIONS MENU, select:
2
1
• Change the position of the X-Y axes with the buttons:
• On the top left of the display it is possible to view the
height to be modified.
• Save your changes by pressing "1".
Note: If you leave the page without pressing the "1" key, all
changes shall be lost.
• To reset the changes and go back to the previous setting,
press "2".
NINJA LASER
5.3.3 Laser keys jaw Setup
How to proceed:
• From the CALIBRATIONS MENU, select:
• Install the required jaw and select the corresponding code
from the JAW SETUP MENU (e.g. A).
2
1
• Press "3" to launch the jaw self-calibration process.
• Follow the instructions on screen.
• Insert the calibration template as requested.
• Alternatively, if necessary, it is possible to calibrate the
system manually, by correcting the position of the X and Y
axes with the keys:
• On the top left of the display it is possible to view the
height to be modified.
• Save your changes by pressing "1".
Note: If you leave the page without pressing the "1" key , all
changes shall be lost.
• To reset the changes and go back to the previous setting,
press "2".
Man. cod. B409927FG
2
1
3
Copyright by Keyline - Italy