Keyline NINJA LASER Use And Maintenance Manual page 48

5. With this button is possible to select the Jaw that has to
be used to cut the key, only compatible Jaws will be se-
lectable.
6. This makes it possible to select the side of the jaw on
which the key shall be cut (see paragraph 4.2.0 on page 7).
7. This makes it possible to select the stop position among
all the various positions in which it is possible to secure
the key in the jaw:
• 0 for keys with rear stop,
• 1-2-3-4 for keys with front stop.
Nota: To be used only if the position proposed by the panel, after
reading or searching the database, does not correspond to
the actual key.
8. This key can be used to change the width of the key blank,
by inputting the desired value manually.
9. This button makes it possible to enable or disable the
search for the key position.
• For further information select "
20 Keyline S.p.A.
MODIFY AND CUT
" from the display.
NINJA LASER Man. cod. B409927FG Copyright by Keyline - Italy