Keyline NINJA LASER Use And Maintenance Manual page 35

4Start up
4.1.0 Notice for machine use
In order for the machine to function under optimum conditions and in
complete safety at all times:
• Keep the power cable away from sources of heat, humidity,
oil, water and sharp objects.
• Keep cutting tools sharpened and clean at all times to en-
sure better and safer performance.
• Do not expose the machine to inclement weather.
• Disconnect the machines power cable before any mainte-
nance, repairs and whenever the machine is not used for a
lengthy period of time.
• Use only original spare parts.
4.1.1 Preliminary controls and setup
Before proceeding with the start up of the machine the oper-
ator must:
• Check to make sure the power cable is correctly connected
to the machine.
• Perform a general visual inspection of the machine to en-
sure that no components have been removed or modified.
4.2.0 How to use the flat keys jaw
The duplicator NINJA LASER has a
four sided rotating jaw. This charac-
teristic allows for gripping of differ-
1
ent keys with the same jaw.
The jaw is made up of two clamps
(lower and upper) that are symmet-
rically constraining and sliding as
well as orientable on 4 sides (A, B, C,
D).
1.Knob for opening / closing
2
2.Lower / upper clamps
3.Gauge
3
Copyright by Keyline - Italy
START UP
Use side A with the flat clamp for keys with single bitting with a cut-
ting depth of more than 4 mm, for keys with a symmetric Z profile and
for cross keys (excluding those that are Y shaped).
Use side B with the flat clamp for keys with a cutting depth of less
than 4 mm and up to a minimum of 3mm.
Use side C with the lower clamp with tooth for keys with double
bitting with right hand profile and side D with the upper clamp
with tooth for keys with double coding with left side profile.
NINJA LASER
4.3.0 Flat key positioning
• Introduce the original key in the jaw (1).
• Extract the tracer point (2) to decode the key.
Note: Lift the gauge (3) until it is flush with the key stop (5).
• Use the knobs (4) to lock the key's position.
• Lower the protective eye guard and start the key reading
program from the console.
2
3
• When the reading is complete, lift the eye guard, release
the original key and remove it from the jaw (1), replacing it
with the key blank for duplication.
• Withdraw the tracer point (2) (otherwise, a warning shall be
displayed on screen).
• Lower the eye guard.
• Start the key cutting procedure.
Man. cod. B409927FG
4
5
1
Keyline S.p.A. 7