Whirlpool W11440958 Technical Manual page 44

COMPONENT ACCESS (Cont.)
6. Lift up grey pad and squeeze hose clamp with pliers and pull
up on hose (see Figures 3).
7. Remove rear access panel, hose, and grey pad (see
Figure 4).
8. Remove five (5) T20 screws as shown in Figure 5.
4-16 Whirlpool 24" Compact Condensing Dryer
n
®
Figure 3
Figure 4
Figure 5
9. Remove plastic water sensor and drain pump support
bracket by lifting up on it (see Figure 6).
10. Remove the foam tape from Water Level Sensor (see
Figure 7).
11. Remove the T20 screw securing the Water Level Sensor and
disconnect wire connector (see Figure 8).
NOTE: When replacing the water level sensor make sure to
remove all water from tray to ensure proper calibration.
Figure 6
Figure 7
Figure 8