Whirlpool W11440958 Technical Manual page 41

13. Remove the bearing support screw shown in Figure 5 (only
remove the indicated screw).
14. Remove the bearing cover and then remove the 10 mm nut
securing the drum to the back panel (see Figure 6).
15. Use a TORX T-20 driver to remove the four (4) screws shown
in Figure 6.
16. Remove the T20 screw holding the wire channel to the back
panel. Squeeze the two retainers together to free the
channel from the back panel (See Figure 7).
Figure 5
Figure 6
Figure 6
Figure 7
COMPONENT ACCESS (Cont.)
17. Back panel can now be removed by lifting up and away
from the drum (see Figure 8).
Whirlpool 24" Compact Condensing Dryer
®
Figure 8
4-13
n